GROUTS by MYK LATICRETE
L500 series sanded grout is made of blended portland cement, graded aggregates, fortifiers and pigments, it provides a tile joint that is strong, hard, durable and colourfast. Designed for joint width of 3mm to 12mm for non-absorbent and vitreous tiles, it is suitable for interior and exterior use.
Areas of Application:- Residential, commercial, external facades
Unit
10kgPrice / Unit
Surface Preparation
Before starting to grout remove spacers and debris in grout joints and remove dust and dirt using a wet sponge. Do not leave water standing in joints.
Mixing
Stir L1776 GROUT ADMIX thoroughly before use. Use approximately 1.75 litres of L1776 for 10 kg
of L500 powder. Place L1776 in a clean mixing container and add grout powder slowly. Mix by hand or with a slow speed mixer to a smooth stiff consistency.
Application
Dampen tile surface with water. Spread with a sharp, firm rubber grout float. Work the grout paste into the joints until completely filled. Use diagonal strokes to pack the joints. Ensure that joint is filled and grout is not just sitting on top
Note: For fuller flush joints sprinkle a thin layer of dry grout powder over surface immediately after grouting.
When grout darkens over joint, buff with burlap, carpet remnant or cotton rag to pack joint and clean face of tile.
Suitable for joints of 3mm - 12mm
Please refer the Grout calculator as it depends
on the tile size, joint width and depth.
© 2020 DCONSTRO Copyright