product_image

MYK LATICRETE 305 GREY

ADHESIVES by MYK LATICRETE

L305 Polymer based adhesive for fixing ceramic tiles and small format natural stone on dry areas of interior floor & interior wall up to a height of 3 Mtrs 

Areas of Application:- Designed for internal floor applications of small ceramic tiles.

Unit

20kg

Price / Unit

₹272.00
Excludes GST*
Get a quote from our Authorized Dealer "ShubhTiles" (Vile Parle, Mumbai)
Get Quote

Application

Surface Preparation:

  • If a plaster/leveling mortar bed is applied, ensure that it is cured for at least 7 days to achieve proper strength before application of tile adhesive for installation of tile
  • Ensure the substrate is clean and free from impurities like dust, dirt, debris, oil, grease, curing agents, loose plaster etc
  • Dampen the wall before application of thin set adhesive
  • Clean the back of tile for any dust or coating

Mixing: 

The products can be mixed by hand or slow speed electric drill mixer (less than 300 rpm). Pour potable clean water in a clean container and then add the powder L305 and mix until the mixture becomes creamy and plastic. Do not over mix. Leave the mix to slake for 5-10 min and remix before use. Mix only sufficient quantity of adhesive for immediate need.

 Proportion: 

Approximately 1 bag of  L305 with 5-6 ltrs of water. Adjust quantity of liquid to obtain proper consistency. 


Installation:

  • Wet the surface and remove the excess water before applying the adhesive. Ensure the area is shaded from sunlight. The adhesive shall be applied with the flat side of the trowel using a scraping motion to work the material into good contact with the surface to be covered.
  • Additional mortar is then applied with the notched edge of the trowel.
  • When installing large tiles, spread adhesive onto back of tile in addition to trowelling material over surface to be tiled. Select proper type of notched trowel.

a) Thin Tiles upto size 300 X 300 mm (1’X1’), use a square notched trowel of size 6mm X 6mm to provide a total thickness of 3mm

b) Large Porcelain Tiles upto 450 X 450 mm with ribs, use a square notched trowel of size 6mm X 6mm and back butter the tiles with the same adhesive to a thickness of 1-1.5mm to provide a total thickness of 4.5mm

c) Large Porcelain Tiles upto 600 X 600 mm (2’X2’) with ribs, use a square notched trowel of size 6mm X 9mm and back butter the tiles with the same adhesive to a thickness of 1-1.5mm to provide a total thickness of 6mm

  • The most important standard to keep in mind is to insure that the piece of tile is completely bedded in the mortar or adhesive with 100% coverage.
  • Rear face of tiles (especially Porcelain tiles) should be cleaned with damp sponge to clean all the dust. Do not saturate in water.
  • Excess mortar on adhesive shall be cleaned from the surface of the stone with wet cloth or sponge while the mortar is fresh.

Substrate


  • Cement Mortar Beds
  • Cement Plaster
  • Brick Masonry
  • Cement Terrazzo

Coverage

Approx. 45-50 sq. ft. per 20 kg bag with a ¼” x ¼” (6mmx6mm) square notch trowel for a bed of 3mm.

Technical Data Sheet
company logo
About Us Privacy Policy Terms & Conditions Contact Us

© 2020 DCONSTRO Copyright